GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

Removal Procedure


    Object Number: 879678  Size: SH
  1. Remove the front door garnish molding. Refer to Front Side Door Front Garnish Molding Replacement .
  2. Remove the front door trim plate. Refer to Front Door Trim Plate Replacement .
  3. Remove the armrest (3). Refer to Armrest Replacement .
  4. Remove the door trim panel screws (2), located behind the armrest.
  5. Use the J 38778 to disengage the retainers around the outside edges of the door trim panel (1).
  6. Slide the door trim panel  (1) upwards to release the door panel from the door.
  7. Remove the front door panel (1) from the vehicle.

Installation Procedure


    Object Number: 879678  Size: SH
  1. Install the door trim panel (1), by hooking the top of the door trim panel (1) to the door belt line.
  2. Align the door trim panel retainers to the door.
  3. Push towards the door to engage the retainers to the sheet metal.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the door trim panel screws (2).
  6. Tighten
    Tighten the screw (2) to 2.0 Nยทm (18 lb in).

  7. Install the armrest (3). Refer to Armrest Replacement .
  8. Install the front door trim plate. Refer to Front Door Trim Plate Replacement .
  9. Install the front door garnish molding. Refer to Front Side Door Front Garnish Molding Replacement .