Diagnostic Instructions
DTC Descriptors
DTC P0300: Engine Misfire Detected
DTC P0301: Cylinder 1 Misfire Detected
DTC P0302: Cylinder 2 Misfire Detected
DTC P0303: Cylinder 3 Misfire Detected
DTC P0304: Cylinder 4 Misfire Detected
DTC P0305: Cylinder 5 Misfire Detected
DTC P0306: Cylinder 6 Misfire Detected
DTC P0307: Cylinder 7 Misfire Detected
DTC P0308: Cylinder 8 Misfire Detected
Circuit/System Description
The engine control module (ECM) monitors changes in crankshaft speed using input from the crankshaft position sensor. The ECM adjusts the fuel delivery to each cylinder in order to minimize crankshaft speed changes. If the ECM identifies a cylinder or
cylinders requiring an excessive amount of fuel in order to maintain the correct crankshaft speed, a DTC will set.
Conditions for Running the DTC
• | DTCs P0117, P0118, P0335, P0336, P2146, P2149, P2152, P2155 and P062C are not set. |
• | The ECT is more than 40°C (104°F). |
• | The engine is running at idle for more than 10 seconds. |
• | The engine RPM is between 500-1,300 RPM. |
• | The vehicle speed is less than 3 mph. |
• | The calculated fuel rate is between 3 mm³ and 25 mm³. |
• | DTCs P0300-P0308 will run once per ignition cycle when the above conditions are met. |
Conditions for Setting the DTC
130 misfire events have occurred.
Actions Taken When the DTC Sets
DTCs P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, and P0308 are Type B DTCs.
Conditions for Clearing the MIL/DTC
DTCs P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, and P0308 are Type B DTCs.
Reference Information
Connector End View Reference
Component Connector End Views
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Circuit/System Testing
You may operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records list.
- If any DTCs other than P0300-P0308 are set, diagnose those DTCs first.
- If only DTC P0300-P0308 are set, go to
Fuel Injector Balance Test with Tech 2.
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the repair.
Control Module References for ECM replacement, setup, and programming.