Removal Procedure
Caution: Refer to Engine Mounting Caution in the Preface section.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Disconnect the transmission oil cooler lines at the transmission. Refer to
Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection.
- Reposition the transmission oil cooler lines.
- Remove the starter. Refer to
Starter Motor Replacement.
- Remove the engine mount to engine mount bracket bolts.
Caution: Refer to Engine Lifting Caution in the Preface section.
Note: When raising the engine only raise enough to separate the engine mount from the engine mount bracket. Raising any further the fan shroud or the exhaust pipe will require removal.
- Place a suitable adjustable jack on the lower engine boss, raise the engine. Only raise the engine enough to separate the engine mount to engine mount bracket.
- Remove the engine mount to engine bolts.
- Remove the engine mount.
- Remove the engine mount bracket bolts, if necessary.
- Remove the engine mount bracket, if necessary.
Installation Procedure
- Position the engine mount bracket to the frame, if necessary.
Caution: Refer to Fastener Caution in the Preface section.
- Install the engine mount bracket bolts, if necessary. Tighten the bolts to
58 N·m (43 lb ft).
- Position the engine mount to the engine.
- Install the engine mount to engine mount bolts.
- Install the engine mount to engine bolts and tighten to
58 N·m (43 lb ft).
- Using the adjustable jack lower the engine until the mount rests on the bracket.
- Install the engine mount to engine mount bracket bolts and tighten to
65 N·m (48 lb ft).
- Install the starter. Refer to
Starter Motor Replacement.
- Position the transmission oil cooler lines.
- Connect the transmission oil cooler lines at the transmission. Refer to
Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection.
- Lower the vehicle.