Cooling Fan Description and Operation with RPO LMM
Cooling Fan Control
The purpose of the electro-viscous (EV) fan clutch is to maintain powertrain cooling requirements. The engine control module (ECM) monitors the following sensors to regulate the fan speed:
• | Engine coolant temperature sensor |
• | A/C refrigerant pressure sensor |
• | Intake air temperature sensor |
• | Transmission fluid temperature sensor |
• | Ambient air temperature sensor |
The ECM controls the EV fan clutch engagement. The ECM regulates a 12-volt pulse width modulated signal (PWM) to the cooling fan relay. The PWM signal determines the ON time of the relay. As the commanded state of the fan clutch increases, so does the
ON time of the relay. This ON time directly effects the amount of time the solenoid, which is internal to the fan clutch, is energized. When the solenoid in the fan clutch is energized, it opens the spring loaded valve and allows fluid to flow from the storage
chamber to the fluid coupling of the cooling fan clutch, increasing the fan speed. When the solenoid is de-energized, the spring loaded valve closes, and blocks the path of the fluid to the fluid coupling of the fan clutch, reducing fan speed.
The fan has the ability to create a feedback signal, so the ECM has an actual fan speed input. This is done with a hall effect sensor internal to the fan clutch. The ECM supplies a 5-volt reference and a low reference to the hall effect sensor. The hall
effect sensor returns a signal pulse through the cooling fan speed signal circuit in response to the reluctor track passing by the magnetic field of the hall effect sensor.
The scan tool can engage the cooling fan clutch. This is done with the engine controls special function menu screen. To engage the cooling fan, It can take up to 2 minutes for a 100 percent command with the engine at 2,000 RPM. The lower
the engine speed, the longer it will take the fan to engage. To disengage the cooling fan, it can take up to 2 minutes with the engine at 2,000 RPM. The lower the engine speed, the longer it will take to disengage. In lower ambient air temperatures the
cooling fan will engage in less time, however, it will take longer to disengage due to the properties of the fluid vs. temperature.
Under certain conditions the cooling fan may be engaged at engine restart. They are as follows:
• | The cooling fan was engaged at the time the engine was turned off. |
• | The fluid may bleed from the storage chamber into the fluid coupling of the cooling fan. |
Although the fan is commanded off at this time due to a cold start condition. This is the most likely time a vehicle driver will notice that the fan noise is excessive compared to normal engine starts with out cooling fan engaged. As the engine speed
is increased the fan noise will be louder than before. These are normal conditions that can be very intermittent.