Special Tools

For equivalent regional tools, refer to Special Tools.

Warning: Refer to Safety Glasses Warning in the Preface section.




1. Use the J 38834 kit and the J 26941 remover in order to remove the balance shaft rear bearing.

1.1.	Install J 26941 remover legs behind the balance shaft rear bearing and secure.

1.2.	Install the J 38834-1 with the short threaded end through the balance shaft bore in the front of the engine block.

1.3.	Install the J 38834-1 into J 26941 remover .

1.4.	Slide the J 38834-2 onto the J 38834-1 and into the balance shaft bore of the engine block.

1.5.	Install the J 38834 kit bearing, washer, and nut onto the J 38834-1.

1.6.	Using a wrench secure the J 38834-1 and then rotate the J 38834 kit nut clockwise until the balance shaft rear bearing is removed from the engine block.

1.7.	Remove the J 26941 remover from the balance shaft rear bearing.

2. Discard the balance shaft rear bearing.