Engine Flywheel Installation Automatic Transmission

Special Tools

For equivalent regional tools, refer to Special Tools.

1. Install the flywheel to the crankshaft.
2. Install the flywheel washer to the flywheel with the beveled side facing the engine.

Caution: This component uses bolts with a preapplied molybdenum disulfide coating for thread lubrication. Do not remove the coating or use any additional lubricant. Improperly lubricated threads will adversely affect the bolt torque and clamp load. Improper bolt torque and clamp load can lead to engine damage.

3. Install NEW flywheel bolts.



4. Install the J 44643 tool to lock the flywheel.

Caution: Refer to Fastener Caution in the Preface section.




5. Tighten the flywheel bolts in the proper sequence.

5.1.	1st step 79 N·m (59 lb ft).

5.2.	2nd step 60 degrees using J 45059 meter .

5.3.	3rd step 60 degrees using J 45059 meter .

Engine Flywheel Installation Manual Transmission

Special Tools

For equivalent regional tools, refer to Special Tools.

1. Install the pilot bearing.




Warning: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

2. Install the flywheel.

Caution: Refer to Fastener Caution in the Preface section.

Caution: This component uses bolts with a preapplied molybdenum disulfide coating for thread lubrication. Do not remove the coating or use any additional lubricant. Improperly lubricated threads will adversely affect the bolt torque and clamp load. Improper bolt torque and clamp load can lead to engine damage.

3. Loosely install NEW flywheel bolts.



4. Install J 44643 tool to hold the flywheel from rotating.



5. Use the following steps and the proper sequence to tighten the flywheel bolts:

5.1.	Tighten the flywheel bolts to 79 N·m (59 lb ft).

5.2.	Tighten the flywheel bolts to 60 degrees using the J 45059 meter .

5.3.	Tighten the flywheel bolts again to 60 degrees using the J 45059 meter .

6. Remove J 44643 tool .