Note: Clean the area around the sensor. Do not allow debris to enter the engine.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the engine harness electrical connector (2) from the oil pressure sensor.
3. Remove the oil pressure sensor (1).

1. Apply sealant to the threads of the oil pressure sensor, if necessary. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.

Caution: Refer to Fastener Caution in the Preface section.

2. Install the oil pressure sensor (1) and tighten to 49 N·m (36 lb ft).
3. Connect the engine harness electrical connector (2) to the oil pressure sensor.
4. Lower the vehicle.
5. Check and add engine oil, if necessary.