J 41476 Front and Rear Cover Alignment (at crankshaft seal area)
Note:
• Do not reuse the crankshaft oil seal or front cover gasket. • Do not apply any type of sealant to the front cover gasket (unless specified). • The special tool in this procedure is used to properly center the front crankshaft front oil seal. - All gasket surfaces should be free of oil or other foreign material during assembly. - The crankshaft front oil seal MUST be centered in relation to the crankshaft. - An improperly aligned front cover may cause premature front oil seal wear and/or engine oil leaks.
Caution: Refer to Fastener Caution in the Preface section.
7.1. | Tighten the oil pan to front cover bolts to 25 N·m (18 lb ft). |
7.2. | Tighten the engine front cover bolts to 25 N·m (18 lb ft). |