Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Disconnect the input speed sensor (1) electrical connector.
- Remove the input speed sensor bolt.
- Remove the input speed sensor (1) and the bracket assembly from the case.
- Inspect the vehicle speed sensor assembly (1) for any evidence of damage.
Installation Procedure
- Lubricate the input speed sensor seal with automatic transmission fluid.
- Install the input speed sensor (1) and the bracket assembly.
Caution: Refer to Fastener Caution in the Preface section.
- Install the bolt and tighten to
11 N·m (96 lb in).
- Connect the input speed sensor electrical connector.
- Lower the vehicle.