GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Express - AWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Stop Lamp Switch Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.

    2. Object Number: 161509 Size: SH
  2. Disconnect the electrical connector from the stop lamp switch.
  3. Remove the retainer from the brake pedal pin.
  4. Remove the stop lamp switch and the pushrod to the power brake booster from the brake pedal pin.
  5. Unsnap the stop lamp switch from the power brake booster pushrod.

Installation Procedure

    Object Number: 161509 Size: SH
  1. Snap the stop lamp switch onto the pushrod to the power brake booster.
  2. Install the stop lamp switch with the pushrod on the brake pedal pin.
  3. Install brake switch retainer.
  4. Connect the electrical connector to the stop lamp switch.
  5. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.