Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle.
Note: This procedure is for 2WD vehicles. If the vehicle is equipped with 4WD, the output speed sensor is located on the transfer case.
- Disconnect the output speed sensor (2) electrical connector.
- Remove the output speed sensor bolt.
- Remove the output speed sensor (2) and the bracket assembly from the case.
- Inspect the output speed sensor assembly (2) for any evidence of damage.
Installation Procedure
- Lubricate the output speed sensor seal with automatic transmission fluid.
- Install the output speed sensor (2) and the bracket assembly.
Caution: Refer to Fastener Caution in the Preface section.
- Install the bolt and tighten to
11 N·m (96 lb in).
- Connect the output speed sensor electrical connector.
- Lower the vehicle.