- Install the low and reverse accumulator piston spring (74) into the transmission case.
Note: The low and reverse band servo assembly (64-73) is pushed down when tightening the cover bolts. Do not force the low and reverse band servo assembly (64-73) into the servo bore.
- Install the low and reverse band servo assembly (64-73).
- Install the low and reverse band servo cover gasket (63).
- Install the low and reverse band servo cover (62).
Caution: Refer to Fastener Caution in the Preface section.
- Install the 6 low and reverse band servo cover bolts (61). Tighten the bolts to
24 N·m (18 lb ft) in an alternating pattern.