Special Tools
• | J 8001 Dial Indicator Set |
• | J 25025-B Dial Indicator Post and Guide Pin Set |
For equivalent regional tools, refer to
Special Tools.
- Assemble the
J 25025-B guide pin set
by attaching the threaded rod and the dial indicator holder to one of the case extension bolt holes on the transmission
case (7).
- Push the output shaft assembly (671) in to remove any slack.
- Install the
J 8001-3 dial indicator
on the dial indicator holder. Index the
J 8001-3 dial indicator
to the end of the output shaft (671).
- Set the
J 8001-3 dial indicator
to 0.
- Move the output shaft (671) in and out, noting the amount of end play. The correct end play is
0.127-0.508 mm (0.005-0.020 in).
If the end play is not correct, change the output
shaft selective thrust washer (674). Refer to the
Output Shaft Selective Thrust Washer Specifications.
- Remove the tools.