Special Tools

For equivalent regional tools, refer to Special Tools.

1. Place the J 38736-1 seal installer onto the turbine shaft (502).
2. Set the J 38736-1 seal installer to position #1.
3. Using the J 38736-5 seal pusher , install the lower turbine shaft intermediate oil seal ring (501).
4. Remove the tools.




Note: Be sure to use the small chamfered end of the J 38736-3 seal sizer in order to size the lower turbine shaft intermediate oil seal ring. Then use the larger chamfered end of the J 38736-3 seal sizer in order to size the upper turbine shaft intermediate oil seal ring.

5. With the small chamfered end down, place the J 38736-3 seal sizer over the lower turbine shaft intermediate oil seal ring.
6. Leave the J 38736-3 seal sizer on the turbine shaft intermediate oil seal ring for at least 1 minute in order to allow the seal ring to become the proper size.



7. Place the J 38736-1 seal installer onto the turbine shaft (502).
8. Set the J 38736-1 seal installer to position #2.
9. Using the J 38736-5 seal pusher , install the upper turbine shaft intermediate oil seal ring (501).
10. Remove the tools.



11. With the large chamfered end down, place the J 38736-3 seal sizer over the turbine shaft intermediate oil seal ring.
12. Leave the J 38736-3 seal sizer on the turbine shaft intermediate oil seal ring for at least 1 minute to allow the seal ring to become the proper size.



13. Turn the turbine shaft (502) over.
14. Place the J 38736-2 seal installer onto the turbine shaft.
15. Set the J 38736-2 seal installer to position #1.
16. Using the J 38736-6 seal pusher , install the lower turbine shaft rear oil seal ring (503).
17. Remove the tools.




Note: Be sure to use the small chamfered end of the J 38736-4 seal sizer in order to size the lower turbine shaft rear oil seal ring. Then use the larger chamfered end of the J 38736-4 seal sizer in order to size the upper turbine shaft rear oil seal ring.

18. With the small chamfered end down, place the J 38736-4 seal sizer over the lower turbine shaft rear oil seal ring.
19. Leave the J 38736-4 seal sizer on the turbine shaft rear oil seal ring for at least 1 minute in order to allow the seal ring to become the proper size.



20. Place the J 38736-2 seal installer onto the turbine shaft (502).
21. Set the J 38736-2 seal installer to position #2.
22. Using the J 38736-6 seal pusher , install the upper turbine shaft rear oil seal ring (503).
23. Remove the tools.



24. With the large chamfered end down, place the J 38736-4 seal sizer over the turbine shaft rear oil seal ring.
25. Leave the J 38736-4 seal sizer on the turbine shaft rear oil seal ring for at least 1 minute in order to allow the seal ring to become the proper size.