Special Tools
J 25025-5 Dial Indicator Mounting Post - M6 x 1.00
For equivalent regional tools, refer to
Special Tools.
- Install the
J 25025-5 mounting post
into the control valve body bolt hole where the manual shaft detent roller and spring assembly is mounted.
- Install the control valve body gasket (45).
- Install the control valve body spacer plate (46).
- Install the accumulator housing gasket (47).
- Install the 3rd clutch accumulator piston spring (50). This spring is the longer of the 2 accumulator springs.
- Install the 4th clutch accumulator piston spring (49).
- Install the 3rd and 4th clutch accumulator housing (51) onto the control valve assembly (44).
- Install the 6 3rd and 4th clutch accumulator housing bolts (53). Tighten the bolts finger tight and start from one end of the accumulator housing toward the opposite end.
Caution: Refer to Fastener Caution in the Preface section.
- Tighten the 3rd and 4th clutch accumulator housing bolts in the order shown. Tighten the bolts to
11 N·m (97 lb in).
- Remove the
J 25025-5 mounting post
.