GM Service Manual Online
For 1990-2009 cars only

Special Tools

J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure


    Object Number: 828821  Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
  3. Remove the outer tie rod stud retaining nut.

  4. Object Number: 470656  Size: SH
  5. Loosen the jam nut (2) on the inner tie rod (1).

  6. Object Number: 643351  Size: SH
  7. Disconnect the outer tie rod from the steering knuckle using J 24319-B .

  8. Object Number: 470661  Size: SH
  9. Remove the outer tie rod (3) from the inner tie rod (1).

Installation Procedure


    Object Number: 470663  Size: SH
  1. Connect the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).
  2. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 828821  Size: SH
  3. Connect the outer tie rod to the steering knuckle.
  4. Install the outer tie rod retaining nut and tighten to 63 N·m (47 lb ft).
  5. Note: Be sure the power steering gear boot is not twisted after the toe adjustment.

  6. Check the wheel alignment. Refer to Wheel Alignment Measurement.