Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement. Chevrolet Express

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Express - AWD 🢒 Steering 🢒 Steering Wheel and Column 🢒 Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement

Callout

Component Name

Preliminary Procedure

Remove the steering column. Refer to Steering Column Replacement.

Intermediate Steering Shaft Upper Seal

Upper Intermediate Steering Shaft

Caution: Refer to Fastener Caution in the Preface section.

Tighten
62 N·m (46 lb ft)

Steering Wheel Position Sensor

Procedure

Disconnect any electrical connectors as needed.
Transfer the steering angle sensor adapter as needed.

Tip

•	When reusing a steering wheel position sensor, you must install a pin into the sensor before removal or the sensor will lose its centered position and must be discarded. The pin diameter must be in the range of 1-2 mm.

•	A new steering wheel position sensor will come with a pin installed in the sensor. The steering wheel position sensor will already come centered, DO NOT remove the pin until the steering wheel position sensor is properly seated.

•	During installation the steering wheel position sensor must be set with approximately 3 mm gap between it and the bearing adapter.

Steering Shaft Lower Bearing

Tip
Vehicles not equipped with JL4 Active Brake Control will not have a steering wheel position sensor.