Special Tools
J 39400-A Halogen Leak Detector
Removal Procedure
- Disconnect the low pressure switch electrical connector (2).
- Remove the low pressure switch (1) from the accumulator.
- Remove the O-ring seal.
Installation Procedure
- Install the new O-ring seal to the switch. Refer to
O-Ring Replacement.
Caution: Refer to Fastener Caution in the Preface section.
- Install the A/C low pressure switch (1) to the accumulator and tighten to
4 N·m (35 lb in).
- Connect the low pressure switch electrical connector (2).
- Leak test the fittings of the component using the
J 39400-A .