Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .

1

Front Stabilizer Shaft Link Lower Nut (Qty: 2)

Tip
Remove only the lower stabilizer shaft link nuts.

Tighten
80 N·m (59 lb ft)

2

Front Stabilizer Shaft Clamp Nut (Qty: 2)

Tighten
50 N·m (37 lb ft)

3

Front Stabilizer Shaft Clamp Bolt (Qty: 2)

Tighten
50 N·m (37 lb ft)

4

Front Stabilizer Shaft Clamp

5

Front Stabilizer Shaft Insulator

Tip
Place the cut line of the insulator facing the rear of the vehicle.

6

Front Stabilizer Shaft

Tip
Remove the front stabilizer shaft from the right side of the vehicle.