Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Open the liftgate.
2. Remove the liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement .
3. Disconnect the 2 license plate lamp bulb sockets by turning a quarter turn counterclockwise.
4. Disconnect the electrical connector for the liftgate latch switch.

1

Nuts, Liftgate Center Applique (Qty: 2)

Tighten
2 N·m (18 lb )

2

Bolts, Liftgate Center Applique (Qty: 2)

Tighten
2 N·m (18 lb )

3

Applique Assembly, Liftgate Center

Tip
Pull the liftgate applique downward, using a slight angular motion to release the studs from the inner liftgate panel.