Preliminary Procedures

1. Remove the liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement .
2. Remove the two upper outer access hole plugs on the inner liftgate panel in order to access and remove the outer spoiler nuts.

1

Nut (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
3 N·m(27 lb in)

2

Retainer (Qty: 3)

Tip
Ensure the foam gaskets are in place prior to securing the spoiler to the liftgate panel.

3

Rear Spoiler Assembly

Tip
Secure the center retainers prior to securing the inner liftgate panel nuts.

4

Adhesive Tape

Procedure
The spoiler along with the adhesive tape surface should be an ambient temperature of 21°C (70°F) prior to installation. The vehicle should remain the ambient temperature of 21°C (70°F) for at least 1 hour after the assembly of the spoiler to the upper liftgate panel in order to allow the adhesive to develop sufficient bond strength.