Preliminary Procedure

1. Open the doors on the side the molding is being removed from.
2. Remove the wheelhouse liner lower screw at each end of the rocker panel.

1

Rocker Panel Molding Locator Pin

Tip
Align the locator pin with the hole on body side outer panel when installing.

2

Wheelhouse Liner Screw (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

3

Rocker Panel Molding Screw (Qty: 6)

Tighten
5 N·m (44 lb in)

4

Rocker Panel Molding Retainer Clip (Qty: 5)

5

Rocker Panel Molding Assembly