GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 HHR 🢒 Steering 🢒 Steering Wheel and Column 🢒 Ignition and Start Switch Replacement

Removal Procedure
  1. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  2. Disconnect the ignition switch harness connector.
  3. Turn the ignition switch to the run position.

    4. Object Number: 854768 Size: SH
  4. Remove the ignition switch screws.

    5. Important: The ignition switch must be in the run position during removal in order to avoid damage to the ignition switch.

  5. Remove the ignition switch from the steering column.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 854768 Size: SH
  1. Install the ignition switch and screws on to the steering column.

    2. Tighten
    Tighten the screws to 2 N·m (17 lb in).

  2. Connect the ignition switch harness connector.
  3. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .