Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Open the hood.
2. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .
3. Disconnect the headlamp bulbs electrical connectors.

1

Bolts/Screws, Lower Mounting Panel (Qty: 2)

Tip

1. The lower tab on the headlamp composite locks into the front end mounting panel.
2. Release the tab prior to lifting the headlamp capsule from the mounting panel.

Tighten
4.5 N·m (40 lb in)

2

Pins, Locating (Qty: 2)

3

Tabs, Upper Headlamp Mounting (Qty: 2)

Tip
Upon reassembly of the headlamp capsule to the mounting panel, slide the tabs on the capsule up inside the locator holes then position the capsule downward.

4

Panel, Headlamp and Front End Mounting

5

Capsule Assembly, Headlamp

Tip
Aim the headlamps after installation of a new capsule assembly. Refer to Headlamp Aiming .