Brake Pedal Position Sensor Replacement. Chevrolet HHR 2008

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2008 🢒 HHR 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Brake Pedal Position Sensor Replacement

Callout	Component Name
Preliminary Procedure Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement .
1	Brake Pedal Position Sensor Bolt Notice: Refer to Fastener Notice in the Preface section. Procedure Remove the sensor bolt. Tighten 9 N·m (80 lb in)
2	Brake Pedal Position Sensor Procedure Disconnect the electrical connector. Pull the sensor away from the bracket. Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .

Callout

Component Name

Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement .

Brake Pedal Position Sensor Bolt

Notice: Refer to Fastener Notice in the Preface section.

Remove the sensor bolt.

Tighten
9 N·m (80 lb in)

Brake Pedal Position Sensor

Disconnect the electrical connector.
Pull the sensor away from the bracket.
Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .