Preliminary Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the assist step bracket bolts.
3. Remove the wheelhouse liner screws at each end of the assist step.

1

Assist Step Bracket Bolt (Qty: 6)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
10 N·m (89 lb in)

2

Wheelhouse Liner Screw (Qty: 2)

Tighten
1.5 N·m (13 lb in)

3

Integral Retainer Clip (Qty: 5)

Tip
Release the retainer clips from the front fender flange and bodyside panel.

4

Assist Step Locator Pin

Tip
Position the assist step locator pin into the bodyside panel upon installation of the assist step.

5

Assist Step Assembly