Preliminary Procedure

1. Remove the front seat. Refer to Front Seat Replacement - Bucket .
2. Remove the recliner handle. Refer to Driver Seat and Passenger Seat Recliner Handle Replacement .

1

Screw, Seat Riser Finish Cover (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

2

Cover, Seat Riser Finish Front

Tip
Pull out the front and side covers at the same time to gain access to the screw on the back side of the front corner.

3

Screw, Seat Riser Finish Cover

Tighten
2 N·m (18 lb in)

4

Cover, Seat Riser Finish Outboard

Tip

1. Disconnect the seat switch electrical connectors.
2. Remove the switches from the cover if replacing the cover.

1

Screw, Seat Riser Finish Cover

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

2

Cover, Seat Riser Finish Outboard

Tip
Unclip the rear of the cover first then pull away from the front side of the seat to remove.

3

Clip, Retainer