Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the front bumper fascia extension. Refer to
Front Bumper Fascia Extension Replacement.
- Loosen the charge air cooler inlet pipe clamp (1).
- Remove the charge air cooler inlet pipe (2) from the charge air cooler (3).
- Lower the vehicle.
- Loosen the charge air cooler clamp (1).
- Remove the charge air cooler inlet pipe (2) and release the pipe retaining grommet from the engine bracket.
- Remove the pipe from the vehicle.
Installation Procedure
Note: Remove any oil film from inside the pipes.
- Attach the pipe retaining grommet to the engine bracket.
- Install the charge air cooler pipe (2) and tighten the charge air cooler inlet pipe clamp.
Caution: Refer to Fastener Caution in the Preface section.
- Raise the vehicle.
- Install the charge air cooler inlet pipe (2) to the charge air cooler (3).
Tighten
Tighten the clamp to 5 N·m (44 lb in).
- Install the front bumper fascia extension. Refer to
Front Bumper Fascia Extension Replacement.