GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 HHR 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Crankshaft Position Sensor Replacement

Removal Procedure

    Object Number: 1716603 Size: SH
  1. Remove the starter. Refer to Starter Motor Replacement.
  2. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.

    3. Object Number: 1578475 Size: SH
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor.

Installation Procedure

    Object Number: 1578475 Size: SH
  1. Lubricate the CKP sensor O-ring seal with clean engine oil.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the CKP sensor.
  3. Install the CKP sensor bolt and tighten to 10 N·m (89 lb in).

    4. Object Number: 1716603 Size: SH
  4. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
  5. Install the starter. Refer to Starter Motor Replacement.