Removal Procedure
- Disconnect the engine wiring harness electrical connector from either the intake (2) or exhaust (1) camshaft position actuator solenoid valve, as required.
- Remove the exhaust (1) camshaft position actuator solenoid valve bolt and valve, as required.
- Remove the intake (2) camshaft position (CMP) actuator solenoid valve bolt and valve, as required.
- Inspect the solenoid valve O-ring seals from damage, replace as necessary.
Installation Procedure
- Lubricate the solenoid valve O-ring seals with clean engine oil.
Caution: Refer to Fastener Caution in the Preface section.
- Install the intake (2) CMP actuator solenoid valve and bolt, as required.
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Install the exhaust (1) CMP actuator solenoid valve and bolt, as required.
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Connect the engine wiring harness electrical connector to the intake (1) or exhaust (2) camshaft position actuator solenoid valve, as required.