Caution: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the EVAP canister for loose carbon before returning the vehicle to service.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the evaporative emission (EVAP) canister vent solenoid valve electrical connector (2).
3. Remove the harness clip from the canister.
4. Clean any dirt or debris that may be present around the EVAP canister.



5. Disconnect the fresh air tube quick connect fitting (3) from the vent solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service.
6. Disconnect the fuel vent pipe quick connect fitting (4) from the canister. Refer to Plastic Collar Quick Connect Fitting Service.



7. Disconnect the EVAP chassis pipe quick connect fitting (1) from the canister. Refer to Plastic Collar Quick Connect Fitting Service.



8. Remove the EVAP canister bolt (1).



9. Remove the EVAP canister by sliding the canister towards the driver side of the vehicle.

1. Align the EVAP canister retaining feature to the canister bracket.
2. Install the EVAP canister by sliding the canister towards the passenger side of the vehicle.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the EVAP canister bolt (1).

Tighten
Tighten the bolt to 10 N·m (89 lb in).




4. Connect the EVAP chassis pipe quick connect fitting (1) to the canister. Refer to Plastic Collar Quick Connect Fitting Service.



5. Connect the fuel vent pipe quick connect fitting (4) to the canister. Refer to Plastic Collar Quick Connect Fitting Service.
6. Connect the fresh air tube quick connect fitting (3) to the vent solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service.



7. Connect the EVAP canister vent solenoid valve electrical connector (2).
8. Install the harness clip to the canister.
9. Lower the vehicle.