GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the fuse labeled HVAC CTRL (BATT).
  2. Remove the instrument panel (I/P) retainer. Refer to Instrument Panel Retainer Replacement.
  3. Remove the I/P tie bar. Refer to Instrument Panel Tie Bar Replacement.

  4. Object Number: 1552373  Size: SH
  5. Disconnect the recirculation actuator electrical connector.

  6. Object Number: 1552372  Size: SH
  7. Remove the recirculation actuator screw.
  8. Remove the recirculation actuator.

Installation Procedure


    Object Number: 1552372  Size: SH

    Note: The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.

  1. Install the recirculation actuator.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the recirculation actuator screw.
  4. Tighten
    Tighten the screw to 2.2 N·m (19 lb in).


    Object Number: 1552373  Size: SH
  5. Install the recirculation electrical connector.
  6. Install the I/P tie bar. Refer to Instrument Panel Tie Bar Replacement.
  7. Install the I/P retainer. Refer to Instrument Panel Retainer Replacement.
  8. Install the fuse labeled HVAC CTRL (BATT).
  9. Note: Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.

  10. Start the engine and let run for 1 minute.