GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1717515  Size: SH
  1. Disconnect the engine wiring harness electrical connector (2) from the front knock sensor, if required.

  2. Object Number: 1825527  Size: SH
  3. Disconnect the engine wiring harness electrical connector (2) from the rear knock sensor, if required.

  4. Object Number: 1717513  Size: SH
  5. Remove the front knock sensor clip (1) from the oil level indicator tube, if required.
  6. Remove the rear knock sensor clip (2) from the intake manifold brace, if required.

  7. Object Number: 1769811  Size: SH
  8. Loosen the appropriate knock bolt.
  9. Remove the appropriate knock sensor.

Installation Procedure

Note: Rotate the pigtail 90 degrees from vertical before securing the fastener.


    Object Number: 1769811  Size: SH
  1. Position the appropriate knock sensor to the engine block.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Tighten the appropriate knock bolt to 25 N·m (18 lb ft).

  4. Object Number: 1717513  Size: SH
  5. Install the front knock sensor clip (1) to the oil level indicator tube, if required.
  6. Install the rear knock sensor clip (2) to the intake manifold brace, if required.

  7. Object Number: 1825527  Size: SH
  8. Connect the engine wiring harness electrical connector (2) to the rear knock sensor.

  9. Object Number: 1717515  Size: SH
  10. Connect the engine wiring harness electrical connector (2) to the front knock sensor.