Brake Pedal Position Sensor Replacement. Chevrolet HHR 2009

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 HHR 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Brake Pedal Position Sensor Replacement

Callout	Component Name
Preliminary Procedure Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement.
1	Brake Pedal Position Sensor Bolt Caution: Refer to Fastener Caution in the Preface section. Procedure Remove the sensor bolt. Tighten 9 N·m (80 lb in)
2	Brake Pedal Position Sensor Procedure Disconnect the electrical connector. Pull the sensor away from the bracket. Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.

Callout

Component Name

Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement.

Brake Pedal Position Sensor Bolt

Caution: Refer to Fastener Caution in the Preface section.

Remove the sensor bolt.

Tighten
9 N·m (80 lb in)

Brake Pedal Position Sensor

Disconnect the electrical connector.
Pull the sensor away from the bracket.
Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.