Preliminary Procedure

1. Open the liftgate.
2. Remove either the LH or RH rear quarter trim panel access hole cover.
3. Disconnect the electrical connector at the backup lamp bulb socket.

1

Backup Lamp Assembly Nuts (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
6 N·m (53 lb in)

2

Backup Lamp Assembly Bracket

Tip
Pull the bracket toward the front of the vehicle off the backup lamp studs.

3

Backup Lamp Assembly

Tip
Remove the lamp assembly from the exterior of the rear body panel.