Removal Procedure
- Remove the steering column trim covers. Refer to
Steering Column Trim Cover Replacement.
- Disconnect the ignition switch harness connector.
- Turn the ignition switch to the run position.
- Remove the ignition switch screws.
Note: The ignition switch must be in the run position during removal in order to avoid damage to the ignition switch.
- Remove the ignition switch from the steering column.
Installation Procedure
Caution: Refer to Fastener Caution in the Preface section.
- Install the ignition switch and screws on to the steering column.
Tighten
Tighten the screws to 2 N·m (17 lb in).
- Connect the ignition switch harness connector.
- Install the steering column trim covers. Refer to
Steering Column Trim Cover Replacement.