Table 1: | Power Steering Control Module Scan Tool Data Parameters |
Table 2: | Power Steering Control Module Scan Tool Output Controls |
Parameter | System State | Expected Value | Description |
---|---|---|---|
Operating Conditions: Ignition ON | |||
Calculated System Temperature | -- | Varies | This displays °C (°F). This is the calculated system temperature. |
Overload Protection Incidents | -- | Varies | This displays a numeric value. |
Steering Shaft Torque | -- | Varies | This displays N-m. |
Steering Wheel Position | -- | Varies | This displays °. This is the current steering wheel position measured in degrees. |
Vehicle Speed Status | -- | Valid | The scan tool displays Valid or Invalid. This is the status of the vehicle speed. |
Output Control | Description |
---|---|
Steering Pos./Torque Sensor Cal. | This output control is used to calibrate the steering position / torque sensor. |
Parameter | System State | Expected Value | Description |
---|---|---|---|
Operating Conditions: Ignition ON | |||
Battery Voltage | -- | Varies | This displays Volts. This is the current battery voltage. |
Ignition Voltage | -- | Varies | This displays Volts. This is the current ignition voltage. |
Motor Voltage + | -- | Varies | This displays Volts. |
Motor Voltage - | -- | Varies | This displays Volts. |
Steering Calibration | -- | Varies | This displays a numeric value. |
Steering Shaft Torque | -- | Varies | This displays N-m. |
Vehicle Speed | -- | 0 km/h (0 mph) | This displays km/h (mph). This is the current vehicle speed. |