Removal Procedure
- Disable the supplemental inflatable restraint (SIR) system. Refer to
SIR Disabling and Enabling.
- Position the steering column tilt in the full downward position.
- Unsnap and remove the upper steering column trim cover.
- Remove the lower steering column trim cover screws.
- Remove the lower steering column trim cover.
Installation Procedure
- Install the lower steering column trim cover.
Caution: Refer to Fastener Caution in the Preface section.
Note: Tighten the lower steering column trim cover screws in the mandatory torque sequence shown.
- Install the lower steering column trim cover screws.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Install the upper steering column trim cover.
- Push on the upper steering column trim cover until it snaps into place and is secure.
- Enable the SIR system. Refer to
SIR Disabling and Enabling.