Spring shims for minor correction of low trim height are available from GMWDD. The shims can be used on 1977 through 1985 rear wheel drive vehicles as listed below:
1978 - 1981 - Malibu and Monte Carlo 1982 - 1985 - Monte Carlo 1977 - 1984 - Caprice 1977 - 1985 - Impala
These shims are 1/8" thick, and no more than two (2) are to be used at each spring location. When used on a front spring, the vehicle's trim height at the wheel opening will be increased approximately two (2) times the thickness of the shim. When used on a rear spring, the trim height will be increased approximately the same amount as the thickness of the shims.
Part Description Part Number ---------------- -----------
Shim, *Front Spring Upper 25524879 Shim, *Rear Spring Lower 25524880
*USE SHIMS ONLY AT LOCATION ON SPRING, AS SPECIFIED ABOVE.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.