For 1990-2009 cars only
Removal Procedure
- Turn OFF the ignition.
- Disconnect the accelerator cable cross slug from the throttle body slot.
- Depress the tangs and remove the accelerator cable from the accelerator cable bracket.
- If applicable, disconnect the cruse control cable from the throttle lever and the accelerator bracket.
- Remove the nuts and the bolts holding the accelerator cable bracket to the throttle body.
- Remove the accelerator cable bracket.
Installation Procedure
- Install the accelerator cable bracket to the throttle body.
- Install the nuts and the bolts.
- Connect the accelerator cable to the accelerator cable bracket.
- Connect the accelerator cable cross slug to the throttle body slots.
- If applicable, connect the cruise control cable to the throttle lever and the accelerator cable bracket.
- Test for complete throttle opening and closing positions by operating the accelerator pedal.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
| • | Tighten the nuts to 10 N·m (88 lb in). |
| • | Tighten the bolts to 13 N·m (115 lb in). |
