GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Impala 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Shift Lever Replacement - On Vehicle

Removal Procedure
  1. Remove the upper and lower steering column trim covers. Refer to Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle

    2. Object Number: 374402 Size: SH
  2. Slide the shift lever seal (2) up the shift lever (4).
  3. Remove the shift lever screw (3).
  4. Remove the shift lever (4).

Installation Procedure

    Object Number: 374402 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the shift lever (4) and secure it with the shift lever screw (3).

    2. Tighten
    Tighten the shift lever screw to 20 N·m (15 lb ft).

  2. Slide the shift lever seal (2) down the shift lever (4).
  3. Install the upper and lower steering column trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle