- Install the turn signal and multifunction switch assembly and secure by using the 2 pan head tapping screws.
- Reconnect the connectors of the turn signal and multifunction switch assembly.
- Install the new wire harness straps onto the wire harness assembly (1).
- Install the wire harness assembly (1) into the wire harness strap (2).
- Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .
Important: The electrical contact of the turn signal and multifunction switch assembly must rest on the contact of the turn signal cancel cam assembly.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
