Removal Procedure
- Remove the rear shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement in Interior Trim.
- Remove the screws from the child seat tether brackets.
- For Impala only, rotate the child seat tether brackets 90 degrees in order to remove the child seat tether brackets from the slot.
- Remove the child seat tether brackets from the rear shelf.
Important: The child seat tether brackets have an anti-rotation tab. For Impala only, you must rotate this tab 90 degrees (Impala only) in order to remove or install the tether to the rear shelf.
Installation Procedure
- Position the child seat tether brackets to the slot in the rear shelf.
- For Impala only, rotate the child seat tether brackets 90 degrees in order to install the child seat tether brackets into the slot.
- Install the screws to the child seat tether brackets.
- Install the rear shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement in Interior Trim.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 20 N·m (15 lb ft).
