GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Impala 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Cruise Control Release Switch Replacement

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

    Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

       • Air bag deployment
       • Personal injury
       • Unnecessary SIR system repairs
    In order to avoid the above conditions, observe the following guidelines:
       • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
       • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

  1. Remove the driver side knee bolster panel. Refer to Instrument Panel Insulator Replacement Knee Bolster Panel.

    2. Object Number: 301720 Size: SH
  2. Remove the electrical connector from the cruise control release switch.
  3. Remove the cruise control release switch from the retainer in the brake pedal bracket.

Installation Procedure

    Object Number: 301720 Size: SH
  1. Install the cruise control release switch to the retainer in the brake pedal bracket.
  2. Install the electrical connector onto the cruise control release switch.
  3. Adjust the cruise control release switch. Refer to Cruise Release Switch Adjustment .
  4. Install the driver side knee bolster panel. Refer to Instrument Panel Insulator Replacement .