GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Did you perform the Radio/Audio System Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Radio/Audio System

2

  1. Turn ON the ignition, with the engine OFF.
  2. Turn ON the radio.
  3. Adjust the radio balance and fade to the suspect speaker.

Does the speaker operate properly?

--

Go to Audio System Troubleshooting Hints

Go to Step 3

3

Is the vehicle equipped with a audio power booster?

--

Go to Step 4

Go to Step 5

4

Is the right or left side speakers inoperative?

--

Go to Step 8

Go to Step 6

5

  1. Turn OFF the ignition.
  2. Disconnect the radio. Refer to Radio Replacement for service procedure.
  3. Momentarily touch a 1.5 volt battery between the appropriate speaker circuits.

Does the speaker emit an audible pop?

--

Go to Step 11

Go to Step 7

6

  1. Turn OFF the ignition.
  2. Disconnect the audio power booster speaker connector. Refer to Radio Speaker Amplifier Replacement for service procedure.
  3. Using two fused jumpers, connect the suspect speaker inputs from the radio to the suspect speaker outputs from the audio power booster in order to bypass the audio power booster.
  4. Momentarily touch a 1.5 volt battery between the appropriate speaker circuits at the radio connector.

Does the speaker emit an audible pop?

--

Go to Step 9

Go to Step 7

7

Test the circuits of the appropriate speaker for an open, short or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 16

Go to Step 10

8

Test the appropriate (right or left) speaker outputs from the audio power booster for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 16

Go to Step 12

9

  1. Reconnect the radio.
  2. Turn ON the ignition, with the engine OFF.
  3. Turn ON the radio.

Can audio be heard from the suspect speaker?

--

Go to Step 12

Go to Step 11

10

Inspect for poor connections at the speaker. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 16

Go to Step 13

11

Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 16

Go to Step 14

12

Inspect for poor connections at the harness connector of the audio power booster. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 16

Go to Step 15

13

Replace the speaker. Refer to Radio Front Speaker Replacement or Radio Rear Speaker Replacement for service procedure.

Did you complete the replacement?

--

Go to Step 16

--

14

Replace the Radio and perform the set up procedure for the Radio. Refer to Radio Replacement and Radio Setup for service procedure.

Did you complete the replacement?

--

Go to Step 16

--

15

Replace the audio power booster. Refer to Radio Speaker Amplifier Replacement for service procedure.

Did you complete the replacement?

--

Go to Step 16

--

16

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2