GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Impala 🢒 Engine 🢒 Engine Mechanical - 3.4L 🢒 Engine Mount Strut Bracket Replacement - Right Side

Removal Procedure
  1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.

    2. Object Number: 462746 Size: SH
  2. Remove the right engine mount strut from the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right Side .

    3. Object Number: 190592 Size: SH
  3. If equipped with oil cooler, remove the oil cooler pipe bracket bolt from the right engine mount strut bracket.
  4. Reposition the air conditioning compressor. Refer to Air Conditioning Compressor Replacement in HVAC.

    5. Object Number: 54655 Size: SH
  5. Remove the vertical bolt from the right engine mount strut bracket.
  6. Remove the right engine mount strut bracket.

Installation Procedure

    Object Number: 54655 Size: SH
  1. Position the right engine mount strut bracket over the pin locator.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the vertical bolt through the right engine mount strut bracket to the cylinder head.

    3. Tighten
    Tighten the engine mount strut bracket bolt to 50 N·m (37 lb ft).

  3. Install the air conditioning compressor. Refer to Air Conditioning Compressor Replacement in HVAC.

    4. Object Number: 190592 Size: SH
  4. If equipped with oil cooler, install the oil cooler pipe bracket bolt to the right engine mount strut bracket.

    5. Tighten
    Tighten the oil cooler pipe bracket bolt to 10 N·m (89 lb in).


    Object Number: 462746 Size: SH
  5. Install the right engine mount strut to the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right Side .
  6. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.