GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

Use care when handling the coolant sensor. Damage to the sensor will affect proper operation of the Fuel Control System.

  1. Partially drain the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.
  2. Disconnect the engine coolant temperature (ECT) sensor electrical connector.

  3. Object Number: 186069  Size: SH
  4. Remove the ECT sensor.

Installation Procedure

Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.


    Object Number: 186069  Size: SH

    Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

  1. Coat the threads with sealer GM P/N 12346004 (Canadian P/N 1095340), or equivalent.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the ECT sensor.
  4. Tighten
    Tighten the sensor to 20 N·m (15 lb ft).

  5. Connect the ECT sensor electrical connector.
  6. Fill the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.