GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Impala 🢒 Engine 🢒 Engine Controls - 3.8L 🢒 Accelerator Pedal Replacement

Removal Procedure

    Object Number: 12287 Size: SH
  1. Remove the left instrument panel sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages, and Console.
  2. Remove the accelerator cable (5) from the accelerator pedal (1).
  3. Remove the bolt (3) and the stud (2) from the accelerator pedal (1).
  4. Remove the accelerator pedal (1).

Installation Procedure

    Object Number: 12287 Size: SH
  1. Position the accelerator pedal (1) to the bulkhead (4).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the accelerator pedal bolt (3) and the stud (2).

    3. Tighten
    Tighten the bolt and the stud to 5 N·m (44 lb in).

  3. Install the accelerator cable (5) to the accelerator pedal (1).

    4. Important: The throttle should operate freely without binding between a fully closed and a wide open throttle.

  4. Verify for complete throttle opening and closing positions by operating the accelerator pedal. Inspect for proper carpet fit under the accelerator pedal.
  5. Install the left instrument panel sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages, and Console.