GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Impala 🢒 Engine 🢒 Engine Controls - 3.4L 🢒 Air Cleaner Assembly Replacement

Removal Procedure
  1. Turn OFF the ignition.
  2. Remove the 3 bolts from the inner fender brace and remove the brace.
  3. Disconnect the intake air temperature (IAT) sensor electrical connector.
  4. Disconnect the mass air flow (MAF) sensor electrical connector.
  5. Disconnect the air tube from the air intake duct.
  6. Loosen the clamp securing the MAF sensor to the air cleaner housing.
  7. Loosen the clamp securing the air duct to the throttle body.
  8. Carefully remove the air intake duct/MAF sensor from the throttle body and air cleaner housing.
  9. Remove the 2 screws (2) from the 2 air cleaner housing sections.

    10. Object Number: 444496 Size: SH
  10. Remove the air cleaner cover assembly (1).
  11. Without disconnecting the powertrain control module (PCM) connectors, remove the PCM and the harness from the PCM housing.

    12. Object Number: 444479 Size: SH
  12. Carefully remove the PCM housing (1) by pulling the cover from the 2 rubber grommets (2) in the engine compartment. Inspect the assembly for signs of damage and replace if required.

Installation Procedure

    Object Number: 444479 Size: SH
  1. Carefully install the PCM housing by pushing the cover (1) into the 2 rubber grommets (2) in the engine compartment.
  2. Carefully install the PCM and harness into the PCM housing (3).
  3. Install the air cleaner housing cover assembly.

    4. Object Number: 444496 Size: SH
  4. Install the 2 screws (2) from the 2 air cleaner housing sections.
  5. Carefully install the air intake duct/MAF sensor to the throttle body and air cleaner housing.
  6. Tighten the clamp securing the air intake duct to the air cleaner housing.
  7. Connect the air tube from the air intake duct.
  8. Connect the MAF sensor electrical connector.
  9. Connect the IAT sensor electrical connector.
  10. Position the inner fender brace and install the 3 bolts.