Schematic Reference: Brake Warning System Schematics

Connector End View Reference: Hydraulic Brake Connector End Views

1

Did you perform the Hydraulic Brake Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Hydraulic Brakes

1. Turn ON the ignition, with the engine OFF.
2. Release the park brake.
3. With a scan tool, observe the Park Brake Switch parameter in the Body Control Module data list.

Does the scan tool indicate that the Park Brake Switch parameter is Off?

Go to Step 5

Go to Step 3

1. Turn OFF the ignition.
2. Disconnect the park brake switch.
3. Turn ON the ignition, with the engine OFF.
4. With a scan tool, observe the Park Brake Switch parameter.

Does the scan tool indicate that the Park Brake Switch parameter is Off?

Go to Step 6

Go to Step 4

Test the park brake switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 8

Go to Step 7

Replace the instrument panel cluster (IPC). Refer to Instrument Cluster Replacement in Instrument Panel, Gages and Console.

Did you complete the replacement?

Go to Step 8

--

Replace the park brake switch. Refer to Parking Brake Indicator Switch Replacement in Park Brake.

Did you complete the repair?

Go to Step 8

--

Replace the body control module. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2